2021 Championship Autocross Event #6 info on Aug 15, 2021 (146874) | MotorsportReg.com

This event is over! Can we show you some more events nearby?

2021 Championship Autocross Event #6


2021 Championship Autocross Event #6

SCCA - Chicago Region - Autocross

Sunday, August 15, 2021
Rt. 66 Raceway, Joliet, IL

Registration closed August 15, 2021 8:15 AM at 2021-08-15T06:15:00-0700 Registration ends August 15, 2021 8:15 AM at 2021-08-15T06:15:00-0700 Registration opens July 19, 2021 12:00 AM at 2021-07-18T22:00:00-0700 Registration runs from July 19, 2021 12:00 AM to August 15, 2021 8:15 AM

Full Event Schedule and Rules can be found on our site here:
http://scca-chicago.com/chicago-scca-solo/1225-2/

Must Pre-Pay on MotorsportReg!
No Cash or Credit Card Payment will be accepted on site!

Your card will be charged 24 Hours prior to the event.  You must cancel by 7am of the event day to ensure full refunds.  All other exceptions subject to the discretion of the Board.  Prompt communication is the most important factor.

PLEASE FILL OUT AND BRING WITH TO EVENT (TECH SHEET)
https://scca-chicago.com/wp-content/uploads/Solo_Tech_Sheet.pdf

NO LOANER HELMETS WILL BE AVAILABLE! 

Use the following link for speed waiver (to avoid manual waiver)

https://sccachicagosolo.speedwaiver.com/sslhm

 

Please read the COVID-19 Requirements on the SCCA Website
https://www.scca.com/pages/solo-1588021531-21

----------
Race Day Schedule:
7:15am to 8:15am     Registration
7:20am to 8:20am     Worker Assignment
7:15am to 8:40am     Tech Inspection
7:30am to 8:55am     Course Walking (No new course walks can begin after 8:50am, except for Morning worker staff)
8:40am             Novice Course Walk
9:00am             Drivers Meeting & 1st Heat Worker Check-in
9:15am              First Car Off

We typically finish up around 5:00pm

There will be a hard registration cut off at 8:15am on the day of the event. You are *required* to be prompt if you expect your pre-registration to hold! Showing up after that doesn't allow you time to walk the course. Drivers not familiar with the course often get lost and slow the event down which isn't fair to others, and the waitlist is filled starting at 8:15
 

Entry Fees:
$41 for Chicago Region SCCA Member Early Registration (closes four days before event)
$46 for Chicago Region SCCA Member Week Of Registration (closes one day prior to the event)
$51 for Chicago Region SCCA Member On-Site registration
$56 for Non-Member Early Registration (closes four days before the event) -- Cost Includes SCCA Weekend Membership
$61 for Non-Member Week of Registration (closes one day prior to the event) -- Cost Includes SCCA Weekend Membership
$66 for Non-Member On-Site Registration  -- Cost Includes SCCA Weekend Membership


Are you new? 

  • New Driver Liaisons will be available throughout the event if you should have any questions/concerns. Please ask at registration and listen to announcements made throughout the morning.
  • Arrive at site between 7:00am-7:30am
  • Listen for announcements made regarding the New Driver Liaisons and New Drivers
  • Proceed to registration (Refer to Registration), and be sure to obtain a Work Assignment
  • Return to car, make car race ready and proceed to Technical Inspection. (Refer to Technical Inspection)
  • Return car to paddock and proceed to start of course to get work assignment. (Refer to Registration)
  • Walk the course.
  • Meet New Driver Liaison near the start of course for New Driver Course Walk at 8:40am ( a few earlier walks may also occur if it can be coordinated)
  • We run rain or shine in all kinds of temperatures. However, the event will be temporarily suspended while lightning is observed in the immediate area. Please bring appropriate rain/cold/hot/sunny weather gear. Make sure you also bring something to cover and/or secure your gear while it is not in your car (plastic garbage bags or a tarp)

Note: Novice Class drivers run with their standard class (ie. N-STX would run & work with STX).

Note: Ladies Class drivers run with their standard class (ie. L-STX would run & work with STX).

Note: Though we try to avoid making changes whenever possible, you must listen for announcements in case a class has changed it's Run/Work Heats.